PRODUCTS

• PB, PC, PL Floodlights

PRODUCTS LINES

• Wellglass
• Floodlights

PB, PC, PL Floodlights

Applications

• Enclosed and gasketed fixtures suitable for use in:
  — Marine and wet locations
  — Areas where flammable gases, vapors or combustible dusts are
      present under conditions defined by the IEC as Zone 2 and 22
  — Applications where energy efficient, high lumen output is
      required
  — Non-hazardous locations where severe weather conditions,
      excessive moisture, dirt, dust, corrosive atmosphere or high
      ambient temperatures are encountered
• Typical applications include:
  — Pulp and paper mills
  — Processing plants
  — Chemical plants
  — Oil refineries
  — Foundries
  — Manufacturing plants
  — Storage areas
  — Waste and sewage treatment
  — Other areas where dust, water, dirt and rough usage are a problem
Features:
• Power supply 230/240 V (+6% - 10%) 50 Hz.
• Instant relighting with auxiliary halogen lamps, depending on  model (lamps not supplied).
• Fast relighting for 70 W and 150 W high pressure sodium: 5  to 30 seconds depending on the duration of the mains power supply failure.
• Connection via terminal block — 2 x 4 mm² (0.003 x 0.006 in²) maximum.
• Superior corrosion-resistance: copperfree die-cast mounting  hoods, ballast housing and guards have a gray epoxy powder  coat, electrostatically applied for complete and uniform  protection.
• Wide choice of light sources: high pressure sodium, metal  halide, mercury vapor and incandescent.
• Six mounting arrangements to suit any lighting layout – pendant,  ceiling, wall bracket, angled or straight stanchion and pendant  cone (for dust applications).
• Hinge has high lip for added safety during installation and servicing. Hinge and bolt construction assures 360°
  compression at all points on ballast housing gasket for positive sealing. Swing away design of captive bolt and nut simplifies servicing.
• All fi xtures designed to perform in a -40 °C (-40 °F) ambient temperature up to +55 °C (+131 °F).
• Standard dome or 30° angle reflectors made of fiberglass reinforced white polyester. Highly resistant to corrosive
  atmospheres and vented to improve fixture cooling characteristics.
• Fixture housing mounting hoods and guards are die-cast copperfree aluminum with epoxy powder coat finish.
• All exposed hardware is stainless steel and captive. Stainless thread inserts in the ballast bodies prevent “freezing” of the screws that affix guards and reflectors, simplifying removal for service.
• One piece ballast housing for each component provides even heat dissipation for cooler operation and longer ballast life.
• Fixture bodies are provided with two silicone rubber O-Ring style gaskets that will stay flexible and assure even compression around their circumference. They easily withstand high temperatures, moisture, dirt and dust for worry free operation.

 PB, PC, PL Series Floodlights                                  

II 2 GD                                                        

PB Series Floodlights Catalog Pages

Floodlight