PB, PC, PL Floodlights

Applications

• Enclosed and gasketed fixtures suitable for use in:
— Marine and wet locations
— Areas where flammable gases, vapors or combustible dusts are
present under conditions defined by the IEC as Zone 2 and 22
— Applications where energy efficient, high lumen output is
required
— Non-hazardous locations where severe weather conditions,
excessive moisture, dirt, dust, corrosive atmosphere or high
ambient temperatures are encountered
• Typical applications include:
— Pulp and paper mills
— Processing plants
— Chemical plants
— Oil refineries
— Foundries
— Manufacturing plants
— Storage areas
— Waste and sewage treatment
— Other areas where dust, water, dirt and rough usage are a problem
Features:
• Power supply 230/240 V (+6% – 10%) 50 Hz.
• Instant relighting with auxiliary halogen lamps, depending on  model (lamps not supplied).
• Fast relighting for 70 W and 150 W high pressure sodium: 5  to 30 seconds depending on the duration of the mains power supply failure.
• Connection via terminal block — 2 x 4 mm² (0.003 x 0.006 in²) maximum.
• Superior corrosion-resistance: copperfree die-cast mounting  hoods, ballast housing and guards have a gray epoxy powder  coat, electrostatically applied for complete and uniform  protection.
• Wide choice of light sources: high pressure sodium, metal  halide, mercury vapor and incandescent.
• Six mounting arrangements to suit any lighting layout – pendant,  ceiling, wall bracket, angled or straight stanchion and pendant  cone (for dust applications).
• Hinge has high lip for added safety during installation and servicing. Hinge and bolt construction assures 360°
compression at all points on ballast housing gasket for positive sealing. Swing away design of captive bolt and nut simplifies servicing.
• All fi xtures designed to perform in a -40 °C (-40 °F) ambient temperature up to +55 °C (+131 °F).
• Standard dome or 30° angle reflectors made of fiberglass reinforced white polyester. Highly resistant to corrosive
atmospheres and vented to improve fixture cooling characteristics.
• Fixture housing mounting hoods and guards are die-cast copperfree aluminum with epoxy powder coat finish.
• All exposed hardware is stainless steel and captive. Stainless thread inserts in the ballast bodies prevent “freezing” of the screws that affix guards and reflectors, simplifying removal for service.
• One piece ballast housing for each component provides even heat dissipation for cooler operation and longer ballast life.
• Fixture bodies are provided with two silicone rubber O-Ring style gaskets that will stay flexible and assure even compression around their circumference. They easily withstand high temperatures, moisture, dirt and dust for worry free operation.